[Jewelry making - Article 01023] - Re: [Orchid] Vacuum casting seal problem

[Jim/Mary]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Had a similar problem... for years!!!>... It was one of 2
    problems... 

    1...Wasn't mixing the casting material according to specification.. 

    2... The pump and the motor are joined together with a flexible
    link... the link was slipping ...'On Occasion' so I 'sometimes'
    couldn't cast...always could pull a vacuum on the air extraction side
    of the caster... 

    Not sure which was the dominate problem as I fixed both at the same
    time... Drove me Nuts... so am very sympathetic.... 

Jimc 


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________