[Jewelry making - Article 01019] - [Orchid] Cutting Copper

[Jocelyn Broyles]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    thanks to all who responded to my last post. 

    i am making a wall sconce. it will be about 14" tall by 9" wide. it
    will have a diamond cutout pattern on it that is repeated several
    times. 

    my jeweler's saw won't reach the middle of the sconce and i'm not
    sure how to best cut out all those little diamond shapes. 

    any ideas are welcome! 

thanks,
jocelyn

Jocelyn Broyles
Designer/President
www.jocelynbroyles.com
Costa Rica ph(011 506) 376.6417
U.S. fax (253) 669.1679

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________