[Jewelry making - Article 00723] - Re: [Orchid] Smith little torch

[Peter W . Rowe]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

>        I'm just kibbitzing, but, if you can't use the smaller tips any
>     more and you need a bigger one, couldn't you just drill out a
>     larger hole in one of your small tips? 

    the smallest three tips sizes are fitted with a drilled syn. ruby
    tip. You can't just drill that larger.  But you can cut off the last
    couple millimeters of the tip, totally removing that ruby tip.  That
    gives you a rather large tip, and you can drill it out even larger if
    you like. 

Peter

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________