[Jewelry making - Article 00457] - [Orchid] Hoke torch problems

[Hsgonnella]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Hi, I have a Hoke torch, which functioned perfectly at first. Soon it
    started to have a very small flame when I turned off the Oxy and
    Propane. I didn't like this, and would give it a little shake and it
    would go right out. I was being lazy about doing anything about it.
    Now, when the propane is turned off it has a good sized flame
    briefly, then gives that annoying pop, then goes out. I am jumpy and
    startle easily as it is, so I just hate this. Everything seems
    tight.....well, my girlish attempts at tightening could be the
    problem. Any help would be greatly appreciated, thanks so much Holly,

Hsgonnella AT aol.com

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________