[Jewelry making - Article 00436] - Re: [Orchid] How to make liner for stone ring?

[Christine Pyman]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

>         but may try soldering one wire on the sleeve, adding the stone
>     ring and the second wire, and burnishing a lip up to hold the ring
>     and second wire in place. Some variant of this is probably the best
>     way to go 

    hey Lee, just had another thought - how about lots of smaller U
    shapes, like very wide jump rings that are only three quarters of a
    circle that you could slip onto the stone ring and then squeeze into
    place. This would give a totally different look I know, but it might
    make your life easier if the customer agrees, have fun, 

Christine


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________