[Jewelry making - Article 00307] - [Orchid] Engraving with Foredom flexible shaft

[Mike Levi]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hi

    Can anyone direct me to a source that gives good instruction on how
    to etch and engrave metal with a flexible shaft tool and a diomond
    tip bur? Or if any of you had some techniques or approaches you could
    share, that would be great. 

    Before you guys suggest using actual gravers or hammer hand pieces,
    let me cut you off at the pass by sayng I can only afford to work
    with what I have at the moment which is a Foredom S and a #30
    handpiece. 

Thanks in advance.
Mike

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________