[Jewelry making - Article 00274] - Re: [Orchid] Position for post earrings backs

[Pam Chott]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

>         I don't think there is a "one place fits all" for soldering on
>     posts. If the design is circular and rotation is not a problem, put
>     the post in the center. Offset the post toward the top of the
>     earring if you want it to always hang a certain way. Just don'tput
>     the post real close to the top edge - allow some coverage forthose
>     whose pierces have stretched over the years. 

Hi Judy, 

    I agree with your assessment on non-oriented circular earrings with
    only one caveat: As the diameter approaches about 1/2 inch, I find
    weight may cause the earring to tip even using the larger clutches. 
    This is especially true if the design includes a stone.  

    In such instances, I prefer to place the post slightly off center,
    preserving a sufficient margin for good coverage. This will nudge
    more weight below the level of the post, allowing the earring to sit
    better on the earlobe.  

Pam Chott
www.songofthephoenix.com

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________