[Jewelry making - Article 00226] - Re: [Orchid] Position for clip-on earrings backs

[Judy Willingham]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hello Grace,

    I don't think there is a "one place fits all" for soldering on
    posts.  If the design is circular and rotation is not a problem, put
    the post in the center.  Offset the post toward the top of the
    earring if you want it to always hang a certain way.  Just don't put
    the post real close to the top edge -  allow some coverage for those
    whose pierces have stretched over the years. 

    An effective backing for heavy earrings are the 1/4" diameter
    friction nuts in sterling or gold. They don't look cheap like the
    plastic discs, and are much easier to handle. I've had customers
    who like them so much that they buy several pairs to use on other
    earrings. 

Hope this helps,
Judy in Kansas


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________