[Jewelry making - Article 00083] - Re: [Orchid] 14K bleeding onto silver

[Judy Willingham]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hello Hans,

    Several have suggested using low temp solders.  I'd also advise
    melting bits of the solder to the back of the gold piece, clean all
    areas of the joint, flux, and heat the silver from below.  The
    advice to use white-out or ocher is also very good. 

    Best wishes and let us know how it comes or came out. 

Judy in Kansas


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________