[Jewelry making - Article 00100] - Re: [Orchid] Chasing Vs. Graving

[Melissa Veres]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Engraving (done with a graver or chisel) actually removes that flake
    of metal as the tool cuts through the surface.  Chasing (done with
    punches and a hammer) moves the metal to create a trough, if done
    with a liner, or a recessed area, if done with a wider punch. 
    Chasing can be used in conjunction with engraving to impart texture
    or shape to an area that has been carved with gravers.  Chasing does
    compress the metal, and will cause it to work harden.

Melissa Veres, Engraver
mveres AT fast.net

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________