[Jewelry making - Article 00089] - Re: [Orchid] Smith oxy-acetylene Torch problem

[David Smith]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Hi Alana. With the tank valve closed you may try disconnecting the
    hose from the regulator. Then crack the tank valve and see if you
    get better flow at that point. If it flows freely the problem is in
    the hose or torch body. If not the problem is in the valve or
    regulator. 

Regards, David 


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________