[Jewelry making - Article 00029] - [Orchid] Scroll saw for 12g sheet

[Kim]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hi there

    I searched the archives regarding scroll saws and the only
    discussion I found was in 1999. 

    My work relies primarily on hand sawing 12g sheet. Needlesstosay I
    saw all the time.  Most jeweler friends think I am insane, but that's
    the direction my work went.  In the past week my arm feels totally
    blown out and of course I knew this could happen but did not prepare.
     The choice of stopping all of it and recreating the wheel is
    overwhelming but perhaps that is the only option unless....... 

    Does anyone know of a scroll saw that will cut with precision, as if
    one used a hand saw, though 12g SS? How about other cutting options? 

Thanks so much for any advice!
Kim

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________