[Jewelry making - Article 00729] - Re: [Orchid] Copal vs. Amber

[Soul Of Wood]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    most important to a carver, is the hardness between the two
    similiar, or the same? was mentioned that copal was tool heated to
    melting point, in that case, you might need less flutes on your flex
    shaft cutters, mill cut burs at slower speeds, wax burs, single flute
    drills,  dp 

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________