[Jewelry making - Article 00707] - Re: [Orchid] Stone bead source

[Greg DeMark]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Noel,

    I don't think you are going to find a source that will consistently
    have a certain drill hole size for beads. Even in a single strand
    you can find different size drill holes on some lower end beads. 

    Have your student buy a Needle or Flame Point shape Diamond Burr. If
    you can't find one small enough from a Jewelers Supply house you may
    also try a Dental Supply House. 

    Have them dip the bead in water and then drill out the holes. Make
    sure they keep dipping the bead in water and work from both sides of
    the hole. 

Good Luck
Greg DeMark
email: greg AT demarkjewelry.com
Website: www.demarkjewelry.com
Custom, Handmade & Antique Jewelry

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________