[Jewelry making - Article 00569] - Re: [Orchid] Perfect Tube measuring and holding tool

[Greg DeMark]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========
Ive,

    Another tool that works great for cutting tube is a ring cutter. 
    This is the tool used to cut a ring off of a persons finger. 

    Due to the teeth on the cutting wheel it is a little more difficult
    to use then the pipe cutter but it works fine once you learn the
    technique. 

Good luck
Greg DeMark
email: greg AT demarkjewelry.com
Website: www.demarkjewelry.com

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________