[Jewelry making - Article 00423] - [Orchid] Tube measuring and holding tool

[Christine Quiriy]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    A friend of mine has the need measure and cut, consistently, small
    sections of small tubing. (I'm not sure how small, but jewelry size,
    and certainly less than 5mm.) How do you all do it? Do you have a
    fabulous tool that allows you to measure and hold the tube for
    cutting? I've seen one of these before but have no idea where to
    find one; not sure if it was an antique or something currently and
    readily available. 

Thanks,
Christine in Littleton, Massachusetts 


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________