[Jewelry making - Article 00181] - Re: [Orchid] Rivets, Wire Gauge and Drill bit sizes

[stephanie smith]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I just wanted to thank everyone for pointing me in the right
    direction.  I printed out a chart from Monsterslayer that I think
    will work just fine.  I am self-teaching myself some basic cold-join
    metalsmithing skills, and am currently interested in rivets.  

    I am using an old fashioned eggbeater style hand drill, and needed
    to purchase some drill bits that corresponded to the various wire
    sizes that I have on hand. (12,14,16,18,20)  I will eventually pick
    up a B&S gauge. 

Thanks again!
Stephanie 


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________