[Jewelry making - Article 00156] - Re: [Orchid] Rivets, Wire Gauge and Drill bit sizes

[E. Luther]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I know I've seen such a chart, and I may actually be able to find
    it. 

    In the meantime, you don't actually need a chart, though I
    understand if you'd like one.  Just take your drill bit and hold the
    end of it up to the end of the wire or tubing that you want to use. 
    This has always worked for me. 

    I'd suggest you check The Complete Metalsmith, Pocket Ref.  I'll
    find my chart and get back to you. 

Elaine
Elaine Luther
Metalsmith, Certified PMC Instructor
http://www.CreativeTextureTools.com
Hard to Find Tools for Metal Clay

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________