[Jewelry making - Article 00603] - [Orchid] More on Soldering Boards

[Catherine Ondrey]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Thanks to everyone that gave me some tips and information on low cost
    soldering boards.  I bought a ceramic 12x12 board the other day and
    am very pleased with the way it doesn't chip up and break apart
    quickly like the white boards I was using.  However, after soldering
    for about 2 hours I nearly panicked when I realized my bench
    underneath the ceramic board was hot enough to possibly self ignite!
    What is a good solution to keep the heat from burning up my bench
    underneath this board? 


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________