[Jewelry making - Article 00123] - Re: [Orchid] Rectangular draw plate

[Donna E. Shimazu]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Debbie,

    Try and contact Otto Frei (formerly Frei & Borel).  They used to
    carry an adjustable die that allowed you to set different dimensions
    for square or rectangular wire.  I believe you used allen wrenches to
    adjust the dimensions. 

    It's not currently listed in their 2004 catalog, but they may have
    one in stock or be able to direct you to a source. It was fairly
    pricey, in excess of  $150. 

<edit>

   Otto Frei on 'Ganoksin's Guide to Industry Web Sites'

   Write a review:
   http://www.ganoksin.com/resources/review.php?id=1475

    Rate Otto Frei
    http://www.ganoksin.com/resources/detail-otto_frei-1475.html

</edit>

HTH,
Donna Shimazu

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________