[Jewelry making - Article 00683] - Re: [Orchid] Tap & Die - Clarification

[Catherine Ondrey]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I should clarify my question - I'm know that I can tap and die a
    small (short) thread, but I'm looking to thread a longer piece to go
    into the tubing - 1-1/2" or so of threaded rod.  Can I do this with
    the conventional tools available?

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________