[Jewelry making - Article 00594] - Re: [Orchid] Stuck shot

[Judy Hoch]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    When I run pieces with open space in any mass finishing process,
    abrasive or steel, I fill the inside with a bit of mesh - like from a
    bag of limes or just mesh fabric. I really shove the mesh inside, and
    leave a little tail, about 1/2 inch long sticking out. When I'm done
    with the mass finishing, I use a chain nose pliers to pull the mesh
    out. It's a bit time consuming to do but it beats the alternative of
    trying to remove the bits of media later. I use this mesh stuff on
    spiculums, the swiss cheese beads and pretty much anything that looks
    like it would get stuff stuck inside. 

Judy  Hoch, G.G.
judy AT marstal.com
www.marstal.com

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________