[Jewelry making - Article 00069] - [Orchid] Finishing Inside Rings

[Mike Dibble]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hi All,

    After several years of customer requests, we are finally ready to
    start production on our first set of ring designs. I was wondering
    if any of you would mind sharing your favorite tools/abrasives or
    techniques for finishing the inside surfaces? I am inclined toward
    using flex shaft tools but if someone has a really good suggestion
    for something that mounts on the buffer, I'm certainly open to that
    as well. 

Thanks in advance!

Mike Dibble
Black Horse Design
www.black-horse-design.com

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________