[Jewelry making - Article 01090] - Re: [Orchid] Cutting Jump Rings

[coralnut]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Susan,

    Absolutely!  I see no real reason to use an 8/0 blade other than it
    gives one a long time to reflect on life ....maybe slow down, enjoy
    cutting with a saw....etc.  You can cut with the blade that is
    normally used for a particular gauge of metal and get just as smooth
    a cut.  Remember, any blade that puts more than two teeth on the
    thickness of the metal is just wasted energy. 

    Cheers from Don at The Charles Belle Studio in SOFL where simple
    elegance IS fine jewelry!

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________