[Jewelry making - Article 00943] - Re: [Orchid] Torch Enameling

[Cameron Potter]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hi Jocelyn,

    I am FAR from an expert at this, more of a dabbler really, but torch
    enameling can be done and in my experience is preferable to kiln
    enameling.  The process is much the same as kiln enameling but when
    it comes to heating, you have to heat it VERY slowly initially and
    the enamel will eventually go black, then heat quickly until the
    enamel goes glossy (or just before that if you want the orange peel
    level for further enameling. 

    I do it with a standard propane torch (not even oxy). 

    I also usually try to avoid heating the enamel directly, so usually
    go for a very thick backing. 

    The one problem I have found with it is that the colours are
    slightly different than kiln firing and I find it VERY hard to get a
    good clear enamel.  It usually goes a little yellow. 

I hope this helps.
Cam

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________