[Jewelry making - Article 00768] - Re: [Orchid] Freaky faulty oxygen tank

[Tom Arnold]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    hello Mona, Don't fool around with this. Immediately bleed the
    pressure off the hose by opening the valve on you torch and
    disconnect the regulator from the tank. After that, come back and
    finish this note. Several things could be wrong but if you turn off
    the valve at the tank and the pressure keeps going up, then there
    must be a faulty valve on the tank. If it goes to 20 lbs, then it
    could go to a thousand. Just call the oxygen company and let them
    deal with it. good luck. 

Tom Arnold

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________