[Jewelry making - Article 00665] - Re: [Orchid] Little Torch problem...

[Joel Schwalb]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Hi Dave, I recall that Smith recommends replacing the hoses every few
    years. I think that the hose material is neoprene. Perhaps it
    deteriorates over time. Also check that the connection is tight. If
    the hoses are in good condition and the connections are tight I don't
    think that 15 psi should be a problem although the highest setting
    that I use is 10 psi for a 4 orifice melting tip. 

Joel
Joel Schwalb
joel4 AT optonline.net
www.schwalbstudio.com

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________