[Jewelry making - Article 00556] - Re: [Orchid] Tumbling / vibro polishing

[Patricia Hicks]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Noel, you are correct that carbon steel shot will not rust if left
    well covered with liquid.  I too have always used Rio's Sunsheen
    compound for burnishing jewelry.  BUT, I use their storage solution
    for putting the steel shot in when not in use for awhile.  In a
    plastic tub with snug lid, under the solution, there's no chance that
    the water will evaporate and cause rust when I'm not looking. 

Pat

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________