[Jewelry making - Article 00506] - [Orchid] Drill bit / bur selection

[Catherine Ondrey]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I need to drill a 5mm hole in 14 guage sterling silver.  I've been
    looking through Stuller and Rio's catalogs, but am uncertain which
    drill/bur to use.  Sawing and hole punching are not an option at
    this point in the design.  Can someone direct me to the right tool? 
    Thanks. 

Catherine

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________