[Jewelry making - Article 00446] - [Orchid] Metal Corrugation tools

[Leah]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I just finished reading Trish McAleer's article on metal corrugation

    http://www.ganoksin.com/borisat/nenam/metal-corrugation-terms.htm

    http://www.ganoksin.com/borisat/nenam/corrugation-project-1.htm

    and was wondering what basic tools people use for this. I can see
    how a rolling mill could enhance certain designs, but what is used
    to create the ridges in the first place? 

-- Leah
www.michondesign.com
leah AT michondesign.com

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________