[Jewelry making - Article 00435] - Re: [Orchid] Tumbling jump rings

[HE2020]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    I never tumble rings unless I have bound them by some type of wire...
    usually scrap silver or some craft wire. Before cutting the rings,
    run a piece of wire through the coil. After cutting, twist the wires
    closed around the cut jump rings. Then tumble them.  This saves you
    from having to fish through the shot to find little itty bitty rings.
    
Helen

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________