[Jewelry making - Article 00195] - Re: [Orchid] PMC printing

[Noel]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

>      I know that you can use a Design (brand) Art Marker, the
>     "Colorless blender," to release the laser toner onto another
>     surface. 

    Could you please elaborate on this? I iron laser toner onto metal
    for etching. Is this a way to do the same without heat? Thanks very
    much! 

--Noel

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________