[Jewelry making - Article 00151] - Re: [Orchid] Cutting jump rings

[Dave]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Hi Dennis,

>     I don't know about a razor blade...I use a jeweler's saw to cut my
>     rings. 

    I'd think the razor blade idea might work with a little
    experimentation on lighter gauge wire. However, to cut heavier gauge
    wire, the Koil Kutter works well. There are Koil Kutter models for
    Proxxon & Dremel motor tools as well as for Foredom #30 handpieces. 

Dave

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________