[Jewelry making - Article 00121] - Re: [Orchid] Cutting Solder Sheet

[lavenderfish]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    In a former life I was a hairdresser. So I use an old pair of
    scissors that are too dull to cut hair, but are wonderful for
    cutting pallions. I cut them off into one of those the little
    plastic frosting cups that comes in a tube of Pillsbury cinnamon
    rolls. Very handy! 

    Also been meaning to pass along this handy "tool" I found not long
    ago while waiting for hubby to find something at AutoZone. It's a
    paint touch-up brush, about the size of a toothpick with a very tiny
    soft bristle on one end and you get 3 in a pack for about $2-3. 
    AWESOME for applying flux to small areas! Just use it, rinse it off
    afterwards and it's good to go for next time. One of those "couldn't
    live without it" objects now always on my bench. 

Have a great day everyone :-) Carol C-W

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________