[Jewelry making - Article 00058] - [Orchid] Cutting Solder Sheet

[Milt Fischbein]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    Thought it would be interesting to find out how everyone likes to
    cut their solder sheets.  I have been cutting with a pair of
    scissors. First I make a number of cuts down one edge of the sheet
    several millimeters appart.  I then cross cut these to make small
    square or rectangular or pallions a few mm by a few mm.  I have tried
    to use solder cutting pliers, but I have not been very successful
    with them. What do others do? 

Regards
Milt Fischbein
Calgary Canada

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________