[Jewelry making - Article 00795] - Re: [Orchid] Laser welding with stones in place

[Antonio Cecena]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Peter

    That sounds good, where can you buy polymer clay. Is this available
    at hardware stores? I normally use low voltage when working close to
    any stone, if its too risky I will pull the stone. I have to say I
    been fortunate so far not to hit a stone ,  but Im curious about the
    clay. 

Tony
Cecenas Jewelry
Belleville , Il

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________