[Jewelry making - Article 00178] - Re: [Orchid] Efficient cutting for 14 ga sheet metal

[Donna Blow]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

Roseann, 

    my suggestion is to contact Dar Shelton at Sheltech.  He can run
    them off for you on the hydraulic press.  You can find his contact
    info at sheltech.net, as well as more information about the kinds of
    dies he can make for you.  He can certainly make a blanking die of
    the pendant shape and even do the stamping for you.  His charges
    have always been reasonable and it will certainly save your precious
    body.  At the end of it, your hand is saved, you have a die master,
    and your shapes are done, requiring only minimal cleanup.  

Donna

____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________