[Jewelry making - Article 00051] - Re: [Orchid] Rolling Mill Problems aligning the rollers

[KARAT46]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========

    When the two rollers are not square (parallel to each other) You
    will be making daggers as one side is lower than the other. To
    remedy this you need to remove the T handle or the wheel that adjust
    the opening and manually rotate the top two gears so both the top
    rollers are parallel. Normally it is better to go down all the way
    till they touch each other and can go no further. Replace the T
    handle a slight readjustment may be needed to set the middle gear. 

    That should clear your problem. 

Regards,
Kenneth Singh
karat46 AT aol.com  


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________