[Jewelry making - Article 01098] - Re: [Orchid] Vigor Flexshaft

[Steve Chancellor]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Lisa, Vigor was purchased by Grobet some years ago. If you need to
    replace the handpiece, almost any you choose should fit. If you need
    a new shaft or sheath, I believe that shafts & sheaths for Buffalo
    and/or Pfingts machinery may fit. I would however measure the
    diameter of the arbor where the shaft connects to the motor, so you
    can check with a supplier, before you purchase either. Hope that
    helps, Steve


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________