[Jewelry making - Article 00030] - Re: [Orchid] Roller replacement for mill

[kevdan]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    It sounds like a copy of a cavalin mill progress machine tool has
    cavalin parts I can resurface the rolls that you have if you want to
    keep them I have an O D grinder and have resurfaced many rolls
    successfully as long as the case hardening is deep enough and the
    damage is not to severe you will not have to reharden them. I can
    also modify the grooves on some rollers as well and make outboard
    rollers that attach to the side of mills. I just repaired a mill
    that someone ran steele screen through in an attempt to transfer the
    pattern to silver but they transfred the pattern permanently to the
    rolls It cleaned up ok but it may need to be reheat treated. hope
    this helps 

Sincerely Kevin Potter


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________