[Jewelry making - Article 01144] - Re: [Orchid] [Source] Brass for Etching

[Katherine Palochak]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


>         Hi, Where do people buy their 16g sheet brass for etching? 

    I think the best source of flat and wire stock in brasses is
    available through Indian Jewelers Supply http://www.ijsinc.com or
    Thunderbird Supply http://www.tbscorp.com Less expensive than other
    sources, will cut to specs and carries up to 36" length (think etched
    brass kick plates for doors). Besides red brass, they have yellow brass, 
    nickel, silverfill and copper.


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________