[Jewelry making - Article 01101] - [Orchid] Water Torches

[doug]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


Hi Folks,

    Just out of curiosity, is there anyone on the list who's used both
    the Turbo-Braze 'Hydroflux Welder' and the Elma 'Hot Flame 100'? If
    so, can you tell me anything about their respective handling
    characteristics and/or limitations, and whether the additional $5 or
    600 for the Elma makes sense for someone transitioning to jewelry
    design and manufacture in a non-gas environment? Also, is anyone
    familiar with the exhaust byproducts of these, during use, and if
    there are any special protection or ventilationneeds to beconsidered?

Many thanks, in advance,
Douglas Turet, G.J.
Lapidary Artist & Designer
doug AT turetdesign.com
http://www.turetdesign.com



____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________