[Jewelry making - Article 01078] - [Orchid] Casting torch upgrade advice needed

[Jeff mack]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    I'm currently using an air/acetylene torch for all my soldering and
    casting.  It works great for the soldering, and ok for the casting,
    as long as the casting is less than an ounce.  I'm needing to cast
    larger quantities than that, so I'm looking at my options. 

    I've seen a few systems from various jewelry tool suppliers.  I've
    also seen much less expensive oxy/acetylene welding/cutting setups
    from non jewelry tool importers for much less money.  

    My tool budget is a bit thin, so I'd like to buy as inexpensive a
    setup as I can.  But I'd rather spend more than I want, then buy
    something that does not work. 

    Any suggestions? 

Thanks,
Jeff


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________