[Jewelry making - Article 01073] - Re: [Orchid] Soldering Enormous Bezels

[Donna Wilson]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Lee, how about trying a kiln assisted soldering job? When I do
    granulation, I use a small table top kiln with the lid off and then
    pass the torch over the top. You could use small right angles of
    scrap copper or silver as supports, raising the belt buckle bezel
    enough to get the torch under. If you set the kiln on a soldering
    pad on top of a lazy susan turner, you could just move the whole
    apparatus in a circle and keep your torch in one place. Donna in VA


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________