[Jewelry making - Article 01048] - Re: [Orchid] Soldering Enormous Bezels

[Christine Pyman]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    hello Lee- does the back have to be a solid sheet ? - i.e. could you
    make it with a couple of flat bars across the bezel instead. This
    should make it easier to solder. if the back does have to be closed
    in, you could rivet the bars to a backing sheet - good luck, 
    Christine


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________