[Jewelry making - Article 00855] - Re: [Orchid] Ivory bracelet

[DAVEMARTAI]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Hi Cindy, I don't want to touch the ivory subject, so, get a tagua
    nut then carve a ring, cut it in half, drill holes in each end to
    accommodate a small wire pin snugly and epoxy together. Tagua nuts
    are available at wood craft supply stores or "google" for tagua nuts
    and you will find endless information there.  If this isn't clear, I
    can draw a picture to send you. 

Marta


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________