[Jewelry making - Article 00800] - Re: [Orchid] Copper questions

[john]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    You can also put a piece of cable through the tube/pipe and pull the
    cable ends and bent the pipe around some object that is the proper
    diameter.  This works well for large diameter, heavy, steel pipe
    when it is needed.  The cable is often pulled with a large
    catapiller tractor and the pipe is bent around a large tree stump
    (not needed here but it sure is interesting to see it done!!!). 

John Dach



____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________