[Jewelry making - Article 00711] - Re: [Orchid] Soldering jump rings that join two sheets

[Mark Shneyer]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


>     Hence I  have decided to add an element at the top so that the
>     cord goes through it. The element in turn is then attached to the
>     pendant. 

    David, Try soldering the jumpringsto the element you want to use
    first.  Then make a clean saw cut into the jumprings to attach them to
    the pendant you made.  You should be able to solder the jumprings
    without the heat problem the same as the first time you did them. 

Mark


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________