[Jewelry making - Article 00645] - Re: [Orchid] Setting cutting seats

[brian]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


>     ... Cab-Cutting bur!!!! (its copyrighted !) Here is where you lose
>     me. Have you photos or drawings of this? ! Invert this new bur and
>     cut away to your 'hearts delight'. 

    I think our Gerry means that a round bur ground with a large
    flatspot at the end will now cut a seat for a cab, as it's shaped
    like a cab... "The flat cut side of the bur is NOW RESTING on the
    bezel's lower edge for the stone to sit on!!!" I believe this lower
    edge is what we grind in the inside wall of the bezel. That is, it
    doesn't exist till we make it, with this helpful tool. 

    How are you Gerry!!! 

Brian
B r i a n   A d a m   
e y e g l a s s e s   j e w e l l e r y
www.adam.co.nz


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________