[Jewelry making - Article 00629] - Re: [Orchid] Setting cutting seats

[JoJu428]

========[ Invite a Friend - http://www.ganoksin.com/invite.htm  ]========


    Dear Gerry, Your usual lucid explanations offered to help us
    understand setting stones does not apply, at least for me, in this
    case. The alteration of the bur is clear enough! You can now cut down
    to the most widest point of that bur, and voila, Cab-Cutting bur!!!!
    (its copyrighted !) Here is where you lose me. Have you photos or
    drawings of this? ! Invert this new bur and cut away to your 'hearts
    delight'. The flat cut side of the bur is NOW RESTING on the bezel's
    lower edge for the stone to sit on!!! Also now with this bur, you
    have made an angle for the Cab to rest 
    'against'.... inside... the wall. 


____________________________________________________________________
T h e   O r c h i d   L i s t
Open Electronic Forum for Jewelry Manufacturing Methods and Procedures
____________________________________________________________________
Orchid FAQ:
~ http://www.ganoksin.com/orchid/faq.htm
Orchid Archives:
~ http://www.ganoksin.com/orchid/archive
Orchid Galleries:
~ http://www.ganoksin.com/orchid/gallery.htm
Invite a Friend:
~ http://www.ganoksin.com/invite.htm
____________________________________________________________________
Tips From The Jeweler's Bench - Article Archive
~ http://www.ganoksin.com/borisat/tip_sear.htm
The Jeweler's Selected Bibliography List
~ http://www.ganoksin.com/jewelry-books
Buy Orchid Jewelry:
~ http://www.ganoksin.com/shop
____________________________________________________________________
-Unsubscribe:
-Email: orchid-request AT ganoksin.com Body=unsubscribe subject=blank
____________________________________________________________________